Description
BELL SUNSCREEN / VISOR – ADJUSTABLE SUITS MAG 10 / HP10 – MULTI LAYER RED
Adjustable anti-scratch Sunscreen / Visor to suit MAG 10, HP10 series Bell Helmets
BELL VISOR / SHIELD INSTALLATION AND CLEANING
It is important to properly remove and install shields onto your helmet to guarantee the highest level of vision clarity and overall protection. By following these simple steps, you will be able to assure your shield is in the best possible condition to succeed in any application.
- Remove both the left and right-side shield / visor pivot screws using the Bell hex wrench provided with your helmet.
- Remove the left and right-side friction sliders and screws using the Bell hex wrench provided.
- Remove the shield / visor from the helmet and inspect for scratches or imperfections that may cause a decrease level of vision clarity.
- Use only the highest quality of automotive, water-based glass cleaner.
- Gently clean the visor using a microfiber cloth to assure a scratch-free cleaning.
- To re-install the shield / visor, place the shield back on the helmet and place the pivot screws back into the helmet. Be sure to not overtighten the screws, as this may damage the screw threads or pivot inserts.
- Replace the friction sliders and screws and adjust to the desired level and close the shield. Adjustment of the eccentric button may be required.
- Check the action and function of the newly replaced shield / visor prior to use to assure the installation was correct.
